12 Points on Mercury Amalgam Removal Protocol
Compiled by Graham Bennett, BSc, ND, BEINZ
Chartered Practitioner of Body Electronics
www.healthybeing.co.nz
1. Have an electrical reading of your amalgams done by a naturopath or
dentist experienced in this area. An electrical current reading gives a
general idea of the speed of electrochemical reactions occurring on the
surface of the fillings. It also reflects the conditions that encourage
conversion of elemental Mercury into methyl Mercury. The higher the
negative charge, the faster the conversion rate. Positive charges are
still detrimental but are of a lower priority. There is no safe level
of Mercury in the body, thus even if a filling may not be leaking much
today, it is only a matter of time before leakage accelerates and
health problems develop.
Charges may change within days, depending on the level of corrosion on
the filling surface. The more serious the health challenge, the more
important is the sequence of removal and testing may need to be
repeated before each session. The sequence should be followed as
closely as possible, most negative to least negative, then most
positive to least positive. The goal is to remove the fillings that are
exposing the body to the highest levels of Mercury first. Although
there is some debate as to whether electrical testing is valid, it is
important that at least either the biggest fillings or the fillings
most likely to leak are removed as soon as possible. Such leakage can
amount to more than half the total amount of Mercury originally present
in the filling. Where did this Mercury go?
As an additional precaution, many dentists recommend not crossing the
midline of the mouth during a session to reduce disruption to the
nervous and meridian systems tied-in with the teeth. In such cases it
is common practice to remove amalgams no more than one quadrant or side
at a time, following the removal sequence as faithfully as possible.
2. Get tested for biocompatibility of replacement filling materials.
Some replacement materials may cause other health problems. As an
example, some materials contain slow-release Fluoride, which destroys
the immune system. More information on Fluoride can be found in
“Fluoride Suspected of Harmful Effects” by Dr Sir John Whitman Ray in
“The Patient’s Guide to Body Electronics”. There is no single material
that is universally biocompatible for everyone. Ideally, a serum (ie.
blood) compatibility test should be performed, but an EAV, MORA or
LISTEN compatibility test is better than no test. Generally, composite
resin materials such as the “Diamond” range are safe bets in the
absence of testing. Avoid the use of metals wherever possible
(especially Nickel and Copper). Even Gold can be incompatible, owing to
the fact that Gold is only used as an amalgam with other often toxic
metals.
3. Start dietary supplementation according to your test results at
least one or two weeks before amalgam removal. This will accelerate
Mercury excretion (both elemental and methyl forms) from the body.
Follow-up testing for toxicity will help identify how long a special
nutritional programme should be followed after amalgam removal.
4. Avoid the 7-14-21 day immune cycle by not having removals performed
on the same day each week. The immune system is weak on these days as
“the guard is changed” from old immune cells to new cells. Also avoid
removal on the 7th, 14th or 21st day after some other immune challenge
such as a flu or other illness. According to Dr Hal Huggins, the “echo”
of old challenges remains in the body for at least this long.
5. Use a dentist who does not place Mercury or fluoride fillings (to
minimise your exposure to Mercury in their office and as a measure of
their commitment to your health) and preferably one who has taken
special precautions in their office to avoid further exposure to
Mercury vapour. These include: special air-purifying ventilation
systems, additional exhaust ducting in the immediate vicinity of the
patient (sometimes hand held), high volume suction and high volume cold
water irrigation equipment handled by an assistant (in addition to the
cold water irrigation from the drill itself), the use of non-toxic
paints, carpeting and furnishings, etc. As a benchmark to assess how
seriously your dentist regards Mercury toxicity, if they take few
precautions for themselves, such as wearing protective gear like face
masks, they probably mistakenly consider the risk low.
6. Many amalgam removal specialists recommend the use of a “rubber
dam”. This is basically a piece of thin latex rubber stretched across
your mouth with only the teeth being worked on exposed to the air. This
minimises the possibility of any splashes of Mercury being ingested
inhaled during drilling. Do not attempt to breathe through the mouth so
as to avoid inhalation of any Mercury vapour which may build up beneath
the dam. If Oxygen is available through a nose piece, use it. Some
dentists consider the dam unnecessary in favour of special high volume
irrigation and suction equipment as above. Let the dentist use the
equipment, techniques and materials they are most experienced with but
make it absolutely clear that no Mercury inhalation or ingestion is
acceptable. 80-100% of inhaled Mercury vapour is absorbed by the lungs
and enters the bloodstream, where it can be distributed to all parts of
the body.
7. Due to its extreme volatility, Mercury vapour pressure doubles with
every 10 degree Celsius increase in temperature. Therefore precautions
to limit this
temperature rise should be employed. Continual cold water irrigation
and sectioning each filling into chunks to reduce temperature rise from
excessive grinding are two such precautions.
8. Ensure complete Mercury removal. In some cases Mercury has been
found beneath composite fillings, in root canals (root-filled teeth)
and in the gums (amalgam tattoo).
9. There are a variety of intraveinous chelation and immune support
compounds that can be administered during and after the actual
dentistry. These substances have a high bonding affinity for Mercury
and are intended to specifically target the removal of residual Mercury
from body tissues to facilitate elimination. Although some of these
compounds may be of a suppressing nature, it should be carefully
considered as to what the highest good is at the time of amalgam
removal. After amalgam removal, the dietary programme should include
some form of chelation substance such as “DMSA” (2,3-Dimercaptosuccinic
Acid) until testing confirms that all Mercury has been released from
the body. An excellent dietary programme accelerates this process
dramatically.
10. Look for a dentist or clinic that can offer an integrated care
package of testing, nutritional advice, dentistry and follow up
testing. No chances should be taken with amalgam removal if any
improvement is to be expected.
11. Avoid exposure to Mercury from other sources such as fish, paints,
cosmetics and some medications.
12. If there is any doubt as to why all metals (particularly Mercury)
should be removed from your mouth, read “12 Points on Mercury Toxicity”
from “The Patient’s Guide to Body Electronics” by Dr Sir John Whitman
Ray and books such as “It’s all in your head” and “Uninformed Consent”
by Dr Hal Huggins, “Silver Dental Fillings, The Toxic Time Bomb” by Sam
Ziff, and “A Patient’s Guide to Mercury-Amalgam Toxicity” by Dr Roy B
Kupsinel.
For articles on
mercury at How We Heal please click here
 |
and your copy of How
We Heal
will be autographed by
author Douglas
W. Morrison. |
| Click
here to discover
the Perfect Diet
for your
metabolism using the Online Questionnaire developed by William Wolcott,
principal author of The Metabolic Typing Diet. |
| Click here to go directly to
the
Grainfields website, where you can get prices and place orders directly
for shipment from Australia to you. |
Nourishing
Traditions by Sally Fallon
Nutrition
and Physical Degeneration by
Weston Price |
| Click
here to
receive price and ordering information by e-mail
on all other
supplements. (Please be sure to
include your NAME & ADDRESS in your e-mail.) |
| Click
here for Aquasana Water & Shower
Filters at a 20%
discount |
Radiation Protection
from cell phones,
computers, etc. click
here
|
Click
here for Oral Chelation
for Heavy Metal Detoxification
|
|

|
"There
is no better way to discover the governing fundamental laws than to
apply the ideal of ultimate simplicity."
Max Born
|
|